The Water (Prevention and Control of Pollution) Act was enacted in 1974 to provide for the prevention and control of water pollution, and for the maintaining or restoring of wholesomeness of water in the country.

● Directions from state government regarding abstracting water from any stream or well as also discharge of sewage and effluents.

●A company shall not knowingly cause or permit any poisonous, noxious or polluting matter determined in accordance with such standards as may be laid down by the State Board to enter (whether directly or indirectly) into any stream or well or sewer or on land to enter into any stream any other matter which may tend, either directly or in combination with similar matters, to impede the proper flow of the water of the stream in a manner leading or likely to lend to a substantial aggravation of pollution due to other causes or of its consequences.

●A Company to take previous consent of the State Board by making Application in prescribed form:

(i) To establish or take any steps to establish any industry, operation or process, or any treatment and disposal system or any extension or addition thereto, which is likely to discharge sewage or trade effluent into a stream or well or sewer or on land or

(ii) To bring into use any new or altered outlet for the discharge of sewage or

(iii) To begin to make any new discharge of sewage.

● If at any place where any industry, operation or process, or any treatment and disposal system or any extension or addition thereto is being carried on, due to accident or other unforeseen act or event, any poisonous, noxious or polluting matter is being discharged, or is likely to be discharged into a stream or well or sewer or on land and, as a result of such discharge, the water in any stream or well is being polluted, or is likely to be polluted, then the person in charge of such place shall forthwith intimate the occurrence of such accident act or event to the State Board.

● Services :

The services are listed as follows:

● Acceptance of Plate Material Certificates or Endorsement of Certificates for Pressure Parts
● Acceptance of Certificates of pipes, tubes, bars
● Acceptance of Heat treatment Chart
● Acceptance of Radiography Reports
● Annual Inspection of Boiler
● Approval of Makers Papers
● Inspection during Repairing of Boiler
● Calibration of UTM / Impact testing Machine
● Certificate & Acceptance of cut pieces of plates
● Change of Ownership of boiler / economizer within state
● Issue of Duplicate Certificate of Manufacturer's Certificate
● Issue of Duplicate Certificate of Welders Certificate
● Grant of Approval as Manufacturer of Pressure vessel, Heat Exchanger, Boiler, Economizer, Valves & Fittings etc.
● Hydraulic Test of Boiler
● Initial / Periodic qualification of electrodes
● Inspection of Boiler-Economizer and boiler components during Manufacturing
● Inspection of casting during manufacturing
● Inspection of Forgings / Pipe Fittings
● Inspection of Valves, Mountings & Fittings
● Inspection during Manufacturing of ERW and Seamless Tubes
● Inspection during Manufacturing of SAW Pipes
● Inspection during Manufacturing of Steel Rolled Bars and Ingots
● Inspection during Modification to Boiler
● Grant of Approval as Pipe Fabricator/Boiler Repairer
● Physical and Chemical Testing of Test Coupons
● Pressure Gauge Calibration
● Provisional Approval of Drawings
● Registration of Packaged Boiler
● Registration of Site Erected Boiler
● Renewal / Endorsement of Welder's Certificates
● Renewal of Grant of Approval as manufacturer of Pressure Vessel, Heat Exchanger, Boiler, etc.,
● Scrapping of Boiler
● Transfer of Boiler from Maharashtra to other State
● Transfer of Boiler from other State to Maharashtra
● Waive of Weld Preparation Inspection
● Welder Qualification - Requalification

● To Avail Services under Environmental Laws Contact us at